A 37% phosphoric acid etchant for enamel and dentin. This etchant has excellent viscosity, flowing well under direction, not under the effects of gravity. Tinted blue for improved visibility, this etchant's silica gel thickener is no obstacle to the adhesive, providing no interference. Made with thixotropic gel, Super Etch non-slump gel offers precise placement.

Features & Benefits:

• 37% phosphoric Acid etchant for enamel and dentin.
• Excellent viscosity.
• Blue tint for visualisation of etchant location.

Product Details:

1 x Super Etch Jumbo Syringe Pack containing:

• 2 x 25ml Super Etch gel syringes
• 1 x Syringe Connector
• 2 x 3ml empty syringes
• 50 single use disposable tips

FAQs:

What are the contraindications of SDI Super Etch?

Soft tissues, if the treatment site cannot be etched, or patients who are allergic to phosphoric acids and blue dyes.

How do I use SDI Super Etch?

SDI has prepared the following instructions for using Super Etch:

1. Isolate tooth. Prepare cavity.
2. Clean the surface to be etched using a nonfluoridated, oil-free prophylaxis paste, or a pumice and water slurry.
3. Rinse thoroughly with water.
4. Thoroughly dry the surface to be etched with dry, oilfree air.
5. CAUTION: DO NOT dispense Super Etch LV without a dispensing tip on. Only use the pre-bent tips supplied.
6. Before dispensing, slightly pull the plunger backward (~1mm) and then push forward.
7. Note: on first usage, or after prolonged storage, extrude a small amount onto a mixing pad for familiarity with the etchant's viscosity and rate of extrusion.
8. Leave on: a. enamel for at least 30 seconds. b. dentin and glass ionomer liner for 20 seconds.
9. Rinse well with water for 5-10 seconds.
10. Remove excess water.
11. Apply bonding agent, or pit and fissure sealant, such as Conseal f, according to manufacturer's instructions.