dentavon ID 900g tub

Aldehyde-free disinfectant based on active oxygen for the disinfection of dental impressions through complete immersion.

For the disinfection of dental impressions made of silicone, polyether, alginate by submersion.

• good material compatibility
• broad spectrum of efficacy (bactericidal, yeasticidal and virucidal)
• based on active oxygen
• uses the immersion method which creates no aerosols and ensures every surface of the impression is disinfected

Microbbiological efficacy:-

• bactericidal EN 13727; EN 14561 clean conditions 5 min. / 20 °C
• yeasticidal EN 13624; EN 14562 clean conditions 5 min. / 20 °C

Viruses

• virucidal activity EN 14476; EN 17111 clean conditions 5 min. / 20 °C

Composition: 100 g contain: 49,5 g pentapotassium bis(peroxymonosulphate) bis(sulphate). Contains: sodium (1-hydroxyethylidene) bisphosphonate, sodium dodecyl sulphate, (+)-tartaric acid

Dosage instructions and information for use:

Rinse off impressions under running water. Fill container with water (max. 30°C), add product and dissolve. The desired batch quantity is indicated in the dosing table. The amount of powder needed must be weighed out. Place impressions in the prepared solution, ensure the appropriate contact time, and then rinse off once again under running water

Note: 900g tub of Dentavon ID (powdered concentrate) makes 90 litres of a 1% in-use solution for disinfecting dental impressions. Earlier, similar product, Perform ID, 900g tub required a 2% concentration and only made 45L. Modern dentavon ID is designed to be effective at a 1% concentration.